Uniden PC78LTD CB Mic + Midland GXT900 Radio Holder with 20mm 67 Designs Ball

We have the perfect mount custom made for your 67 Designs Arm mounted in your vehicle.

Benefits

• Easy to install with no permanent modification to your Jeep.
• Close to reaching yet out of your way.
• Provides a vertical orientation for your handheld radio's antenna to clear the dashboard for optimal reception.
• The radio can be inserted in and taken out in an instant while using just one hand.
• Expandable system - additional rails for other radios and devices are available for purchase on our site if you decide to change your device.
• All our 67 Designs mounts include a free set of Lateral Support Wings.
• A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
• All our designs are rigorously and extensively real-life tested off-road.
• Mount installs in 10 seconds or less installation.
• Safer than other mounts on the market - made of durable plastic - not tin.
• No sharp metal edges that can scratch a pet (or a passenger) bouncing around on that awful back washboard on your way to Monument Valley.
• Made in the USA! All our products are proudly designed and manufactured in sunny Arizona.

Fitment

• Works with any vehicle with a 67 Designs CF set-up.
• We also have RHD (right-hand drive) versions available. To request just send us a note.

The Mic holder for this model:

• Perfect fit for your Uniden PC78LTD Mic.
• Supports any mic for mobile CB/HAM/GMRS radios using round-button type hanger.
• Note that some product images might display other Mobile Mic. However the Mic holder is identical.

The Radio support rail (aka the Vertical Support Rail):

• Custom made to fit the Midland GXT900's belt clip.
• Rails for other radios are available for purchase on our site if you decide to change your device.
• The mount is not compatible with extended batteries that either:
• Make the radio too long such that it interferes with the mount.
• Extend the depth of the device too much such that the unit cannot be secured to the mount.
• Increase the weight of the device by more than 3oz.
• See this article for a better solution
• Since there is no standard belt-clip design we can not guarantee fit for any other devices.
• Depending on the model of your radio we include special spacers to ensure a secure and rattle-free fit.
• Note that some product images might display other Handheld Radio. However the Radio rail is similar but is specific for your device.

Other Notes

• A 20mm Genuine 67 Designs Ball is included and pre-fitted to the mount.
• Note that some product images might display a 1 inch RAM ball set-up. The mount is similar except for using a 20mm 67 Designs ball instead of the RAM one

Installation:

• No tools needed.
• Attach the mount's 20 mm ball to your 67 Designs Carbon Fiber arm.

Important Notes:

• Our products are for off-road use only.
• Our mounts are only designed for light accessories as stated under the Compatibility notes.
• Do NOT modify or overload the mounts with accessories not listed as supported by JeepUniq.
• Obey your local state and federal laws
• JeepUniq is not responsible for any improper or illegal use of our accessories.
• Vehicle's owner is responsible for ensuring that mounts are not in the way of the airbags.
• Note that some product images might display a 1 inch RAM ball set-up. The mount is similar except for using a 20mm 67 Designs ball instead of the RAM one